Software module to flash:

Delphi DCM3.1 ECUs used in SsangYong diesel vehicles. ECU is based on MCU Motorola MPC555 with internal memory 448kb.

Allows to reading of full flash and writing of the calibration area via K-line with checksum calculation.

Delphi DCM3.2AP ECUs used in SsangYong diesel vehicles. ECU is based on MCU Motorola MP563 + external flash AM29BDD160GB with internal memory 2.5Mb.

Allows to reading of full flash and writing of the calibration area via K-line with checksum calculation.

Delphi DCM3.7AP ECUs used in SsangYong diesel vehicles. ECU is based on MCU Renesas SH72543 with internal memory 2Mb.

Allows to reading of full flash and writing of the calibration area via CAN BUS with checksum calculation.

Delphi DCM6.2AP ECUs used in SsangYong diesel vehicles. ECU is based on MCU NXP SPC5673 with internal memory 3Mb

Allows to reading and writing of the calibration area via CAN-bus with checksum calculation. Recovery is possible from any state..

*The J2534 Tactrix Openport 2.0 interface and a BitSoftware Senselock USB dongle are required in order to use this software!

Supported Vehicles:

SsangYong Delphi DCM3.1

– SsangYong Actyon D20DT Euro3
– SsangYong Actyon Sports D20DT Euro3
– SsangYong Kyron D20DT Euro3
– SsangYong Kyron D27DT Euro3
– SsangYong Rodius D27DT Euro3
– Tata Safari 3.0 DiCOR
– Tata Xenon 3.0 DiCOR

SsangYong Delphi DCM3.2

– SsangYong Actyon D20DT Euro4
– SsangYong Actyon Sports D20DT Euro4
– SsangYong Kyron D20DT Euro4
– SsangYong Kyron D27DT Euro4
– SsangYong Rexton D20DT Euro4
– SsangYong Rexton D27DT Euro4
– SsangYong Rodius D27DT Euro4

SsangYong Delphi DCM3.7AP

– SsangYong Actyon Sports D20DTR
– SsangYong Korando C/New Actyon D20DTF
– SsangYong Rexton D20DTR
– SsangYong Rodius D20DTR
– SsangYong Stavic II D20DTR

SsangYong Delphi DCM6.2AP

– SsangYong Tivoli/XLV D16DTF
– SsangYong Rodius/Stavic II D22DTR
– SsangYong Korando C/New Actyon D22DTF
– SsangYong Rexton W D22DTR